Step 29: Heat Sink and Driver Connections

Yes, we've use heat shrink, but now it's time for a heat sink. No, it's not a hot tub. A heat sink is usually a piece of metal that allows something that gets hot to dissipate the heat. It is advised for the three driver chips on the HobbyCNC board. The installation is straight forward. Holes are marked and then drilled. It is important to note that the drill will create many metal shavings. Metal shavings are incompatible to the proper functioning of the driver board. If any of those shavings get on the board, you will risk a blown chip. Before final installation of the heat sink, a white compound should be spread between the component and the metal, like a peanut butter sandwich. Read More...